Star Acrylic Snowglobe Christmas Decoration

Get ready to shake things up with our NEW Acrylic Snowglobe Decorations! ❄️✨

Available in a range of fun designs, these blank acrylic decorations are perfect for getting creative and making completely unique snowglobe designs. Customise them with UVDTF transfers, vinyl, glitter, polyclay slices and more!

Each decoration is supplied in 3 separate acrylic pieces and comes pre-drilled ready for adding your chosen snowglobe solution.

⚠️ PLEASE NOTE: SELF-ASSEMBLY IS REQUIRED.
These decorations are supplied as separate acrylic pieces and will need to be assembled and sealed using UV resin before filling.

How to assemble your snowglobe decoration

1. Start with your first two pieces
   Apply UV resin around the entire outline of the cut-out section.
2. Create your first seal
   Place the non-pre-drilled acrylic piece on top and apply gentle, even pressure. Make sure there are no gaps in the UV resin around the edge, as this creates the watertight seal.
3. Clean up & cure
   Wipe away any excess UV resin that has squeezed out around the edges, then cure thoroughly using a UV lamp. This will bind the first two pieces together.
4. Add the sparkle! ✨
   Once cured, add your chosen glitter, polyclay slices or other suitable snowglobe fillings.
5. Seal the final piece
   Apply another thin, continuous layer of UV resin around the outline of the decoration.
6. Add the pre-drilled piece
   Place the third, pre-drilled acrylic piece on top. Apply gentle pressure and wipe away any excess resin, just as you did before.
7. Cure again
   Cure thoroughly under your UV lamp to bind and seal all three pieces together.
8. Fill your snowglobe 💦
   Using a syringe, carefully add your chosen snowglobe solution through the pre-drilled filling hole.
9. Seal it up!
   Once filled to your preference, place a blob of UV resin over the filling hole and cure immediately to seal.

And you’re done! ✨ Give it time to settle, then decorate with your favourite UVDTF or vinyl design to make it completely your own.

Important Information

• Supplied in 3 separate acrylic pieces
• Self-assembly required
• Pre-drilled filling hole
• UV resin and UV lamp required for assembly
• Glitter, polyclay, snowglobe solution, syringe, UV resin and decorations are not included unless otherwise stated
• Suitable for customising with UVDTF and vinyl
• Please ensure all edges are fully sealed and cured before adding liquid
• As this is a self-assembly product, the finished seal will depend on the assembly process used

9.5cm x 9.5cm approx